How to get charger into pairing mode?

To put your EV charger into pairing mode, follow these steps:

1. Turn Off and On: Turn off the charger from the power supply, wait a moment, and then turn it back on. This will initiate pairing mode, which lasts for about 60 seconds.

2. Check for Hotspot Emission:

   • On your phone, go to Wi-Fi settings and search for available networks.

   • Look for the charger's serial number in the list of networks. Note: Do not connect to this network; it’s just for identification.

   • Once you see the charger's serial number, return to the Installer Miles app.

3. If You Can't See the Serial Number:

   • Turn off the Wi-Fi router.

   • Turn off the charger from the power supply.

   • After a short interval, turn the charger back on.

4. Note: If the Wi-Fi router is left on, the charger may connect to it quickly, preventing the hotspot signal from being emitted for pairing.