How do I use a laptop to configure my charger?

Manually Configuring Your Charger Using a Laptop

Follow these steps to manually configure your charger:

1. Prepare the Required Equipment

   • Ensure you have a laptop and an Ethernet/LAN (RJ45) cable.

2. Set Up Network Configuration

   • Open the network and internet settings on your laptop.
   • Navigate to Ethernet Settings and select Change Adapter Options.
   • Choose the Ethernet adapter, then highlight Internet Protocol Version 4 (TCP/IPv4).
   • Click Properties and select Use the following IP address.
   • Enter the IP address: 192.168.1.3, then click OK and close all windows.

3. Connect to the Charger

   • Connect the Ethernet cable to the LAN port of the charger.
   • Open a web browser on your laptop and enter 192.168.1.5:8080 in the address bar.

4. Log In and Configure Parameters

   • When prompted, log in using the password: 12345678.
   • The parameters page will appear. Update the required parameters.
   • Click Set, then reboot the charger to apply the changes.

This process will allow you to successfully configure your charger settings.