How do I get my charger into pairing mode?

Modified on Wed, 11 Sep at 4:14 AM

To put your EV charger into pairing mode, follow these steps:

  • Turn Off and On:
    • Begin by disconnecting the charger from the power supply.
    • After a brief pause, reconnect the charger. This will activate pairing mode, which lasts approximately 60 seconds.
  • Connectivity Setup:
    • Open your phone's Wi-Fi settings and search for available networks.
    • Look for a network with the charger's serial number in the list. Note: Do not connect to this network; it's used for identification only.
  • Troubleshooting:
    • If the charger's serial number does not appear, perform the following:
      • Power off the Wi-Fi router.
      • Disconnect the charger from the power supply.
      • After a short interval, reconnect the charger.
      • Note: Ensure the Wi-Fi router remains off during this process, as it may otherwise quickly connect to the charger and prevent the emission of a hotspot signal for pairing.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article